5390 Rt Full
5360 Feature 4
5360 Feature 2
5360 Feature 1

5390 37” Double-Head Wide Belt Sanders

  • 75” belts give you longer life and less loading.

  • Double head design allows removal and finish sanding in a single pass.

  • Belt tracking is controlled by photo sensors for superior performance.

  • Central control panel feature digital control for accurate stock height and removal.

  • Heavy precision ground table gives a solid working surface.

  • Power table height adjustment provides for a quick set-up.

  • Variable speed feed motor allows precise adjustment for optimum results.

  • Four post lift design assures accurate consistent results.

  • Oscillating belt is controlled by an air sensor to prevent sanding lines.

  • Platen is fully adjustable.

  • Multiple dust ports for efficient dust management.

  • Independent motors run the sanding belt, feed conveyor, and table elevation for maximum power to each operation.

  • *Optional 440/460 volt available special order only. Additional cost/parts may apply.

Find a dealer
  • 75” belts give you longer life and less loading.

  • Double head design allows removal and finish sanding in a single pass.

  • Belt tracking is controlled by photo sensors for superior performance.

  • Central control panel feature digital control for accurate stock height and removal.

  • Heavy precision ground table gives a solid working surface.

  • Power table height adjustment provides for a quick set-up.

  • Variable speed feed motor allows precise adjustment for optimum results.

  • Four post lift design assures accurate consistent results.

  • Oscillating belt is controlled by an air sensor to prevent sanding lines.

  • Platen is fully adjustable.

  • Multiple dust ports for efficient dust management.

  • Independent motors run the sanding belt, feed conveyor, and table elevation for maximum power to each operation.

  • *Optional 440/460 volt available special order only. Additional cost/parts may apply.

Stock No.
5390.002 (20HP, 3Ph)
Maximum Stock Width
37”
Maximum Stock Thickness
6”
Minimum Stock Thickness
1/8”
Air Requirements
80 PSI
Dust Port Diameter
5” (x6)
Exhaust Value Required
1,600 CFM
Abrasive Belt Dimensions
37”W x 75”L
Feed Speed
Variable, 15 - 49 FPM
Main Motor
20HP, 3Ph, 220/440V* Prewired 220V
Conveyor Motor
1HP, 3Ph 220/440V Prewired 220V
Table Height Motor/Digital Readout
1/4HP
Gross Weight
3,637 lbs
Overall Dimensions
52”L x 80”W x 75”H